Outline Strength Less than 20

Discussion in 'Wish list for future releases' started by LarryT, Nov 29, 2014.

  1. LarryT

    LarryT

    Messages:
    5
    Trophy Points:
    3
    Gender:
    Male
    It would be nice to not have 20 as the minimum for the outline function, is there a particular reason it doesn't allow it to go to say, 1 as the minimum?
     
  2. KD-did

    KD-did

    Messages:
    8,136
    Trophy Points:
    113
    Gender:
    Female
    • It is adjustable. First turn on outline function and then MANUALLY entire size. under 20.png
     
  3. gcuneo2

    gcuneo2

    Messages:
    1,265
    Trophy Points:
    113
    Gender:
    Male
    I'm guessing regardless of whether it's 20, or 1, it's the same width....
     
  4. LarryT

    LarryT

    Messages:
    5
    Trophy Points:
    3
    Gender:
    Male
    That would be correct... it never get's smaller than 20... although it should. It's always rather "thick" for the outline regardless of the value you enter less than 20
     
  5. gunsmoke

    gunsmoke

    Messages:
    949
    Trophy Points:
    63
    Gender:
    Male
    I don't have previous versions installed Glenn...did they work the same way? Minimum of 20?
     
  6. KD-did

    KD-did

    Messages:
    8,136
    Trophy Points:
    113
    Gender:
    Female
    The V5 outline function had it starting at 2 and didn't necessarily require turning on to size outline....but need to set the size.
    Picture 1.png
     
  7. gunsmoke

    gunsmoke

    Messages:
    949
    Trophy Points:
    63
    Gender:
    Male
    Hm, wonder why Marc changed it ???
     
  8. LarryT

    LarryT

    Messages:
    5
    Trophy Points:
    3
    Gender:
    Male
    Marc,
    Changing it back to 2 would be great!
     
  9. gcuneo2

    gcuneo2

    Messages:
    1,265
    Trophy Points:
    113
    Gender:
    Male
    I think it had sumptin' to do with Obama....

    But probably is due to Marc having to use different software to design the basic program.....
     

Share This Page